Safety operation rules of bending machine(ISO9001-2015/ISO45001-2018)1、 Check before startupa) Before starting the machine every day, the operator should check and maintain the machine according to the requirements of daily maintenance and inspection record of equipment to ensure that the machine is in normal working condition before starting the machine for production.b) After daily start-up and before production, the operator shall effectively test the safety deviceWhether the double foot s
The machining allowance of the bending machine needs to be determined through calculation and analysis. For the factors that affect the machining allowance, it is necessary to use test materials and calculation formulas to conduct comprehensive analysis and calculations to determine the finishing allowance. The finishing allowance determined by this method is more economical and reasonable, but there are relatively complete and reliable tests. data. If the machining allowance selected by the bending machine is too large, it will increase the cutting force and affect the machining accuracy and the surface quality of the workpiece. On the other hand, if the finishing allowance is too small, the error left by the workpiece in the previous machining process cannot be eliminated, and surface defects, process clamping errors, etc. will add to the workpiece as a waste.
When using the bending machine for material operation, everyone is required to master the machine equipment pa
When the laser cutting machine cuts large-format and medium-thick metal sheets in the sheet metal industry, in order to improve the utilization rate of the sheet and facilitate programming, the straight edge of the sheet must be parallel to the X-axis processing direction of the machine tool before laser cutting. Normally, manual calibration is used in the method, which has low efficiency, large errors and serious material waste, which affects the processing efficiency.