|
|
The correct method of operating the The correct method of operating the shearing machineTime：2021-08-01 1. Before work, carefully check whether all parts of the shearing machine are normal, whether the electrical equipment is intact, and whether the lubrication system is unblocked; clean the table and its surroundings with tools, measuring tools and other debris and corner waste. 2. Do not operate the shearing machine by one person. Two to three people should coordinate the feeding, control dimensional accuracy and reclaiming, etc., and be sure to have a unified command. 3. Adjust the shear gap of the shearing machine according to the specified shearing thickness. It is not allowed to cut two kinds of sheets of different specifications and different materials at the same time; do not cut by overlapping materials. The cut sheet requires a flat surface, and it is not allowed to cut narrow sheets that cannot be compressed. 4. The belt, flywheel, gear, shaft and other moving parts of the shearing machine must be equipped with a protective cover. 5. The fingers of the shearing machine operator should keep a distance of less than 200mm from the scissors mouth and leave the pressing device. The protective fence installed on the shearing trigger cannot block the eyes of the operator and cannot see the cut part. The waste generated after the operation has edges and corners, and the operator should clean it up in time to prevent stab wounds and cuts. 6. The flywheel, gear, shaft, tape and other moving parts of the shearing machine should be equipped with a protective cover. 7. Place a fence to prevent the operator's hand from entering the area where the scissors fall. It is strictly forbidden to pick up waste on the ground during work to avoid being injured by the falling workpiece. 8. It is not allowed to cut the quenched material, and it is never allowed to cut beyond the working capacity of the shearing machine. |
