Installation and debugging method of die for 100t CNC bending machine?

The mold of 100t CNC hydraulic bending machine is composed of many parts, so special attention should be paid to the installation, and repeated debugging should be carried out when it is completed. Generally, when we install and adjust the bending machine mold, it will be divided into five parts to complete.

1. Before the installation of the machine, the performance of the machine should be adjusted first. This process must be carried out patiently and seriously. Check whether the machine has dust and used iron debris, and carry out necessary cleaning, so as to reduce the trouble in the later stage.

2. When adjusting the slider stroke, pay attention to check the thickness of the mold and check whether the proportion of the upper and lower modules is normal. Normally, the module should be controlled at the switch point of the stroke line, which must be paid attention to.

3. The adjustment of the travel module is to adjust the upper limit point of the module. When the module is up to the highest point, set the switch well and reserve the stop position of the slider. At the same time, the deceleration module should be carried out when the module is down to better protect the machine and the bending machine mold.

4. The gap adjustment is mainly to measure the distance between the upper module and the lower module, and the specific gap setting is determined according to the folded plate.

5. Angle adjustment, the adjustment of this angle has a certain relationship with the product. Generally speaking, when folding 90 ° die, the middle angle must be greater than the angle of both sides, so its tightness can be adjusted according to the adjusting screw. When bending, the pressure can be adjusted through the pressure gauge to avoid die edge collapse.

The above is 100 tons of CNC hydraulic bending machine correct installation debugging bending machine mold method, I hope to help you. The die of 100t hydraulic bending machine is divided into upper die and lower die, which is used for sheet metal stamping and separation.

mould