Adjustment of press brake tool

1. Installation adjustment

When installing the bending machine mold, be sure to check the state of the equipment, and then install and debug according to the steps. Pay attention to personal safety during debugging.

2. Machine adjustment

When installing the bending machine mold, first understand the machine performance, open the bending machine, patiently adjust and check to see if the machine has previously used dust, iron debris, etc. Prevent unnecessary trouble for later use.

3. Adjustment of slider stroke

First check whether the ratio between the thickness of the bending machine die and the upper and lower modules is normal. The general slider needs to be controlled at the switching point of the travel line. This must be paid attention to, otherwise the die will not work normally, but some people still often make such mistakes.

4. Adjustment of travel module

After adjusting the slider travel standard, the next step is to adjust the upper limit point of the module. Generally speaking, when the module goes up to the highest point, it is necessary to set the and switches of the module. In this way, the stay position of the outflow module can be. Through the above operations, the production efficiency can be greatly increased. In this process, you also need to slow down the module. Because when the module goes down to the bottom dead center, it must slow down the module, so as to protect the machine and die.

5. Gap adjustment

Finally, the gap between the bending machine molds is adjusted. First measure the gap between the upper module and the lower module. The reasonable gap needs to be determined according to the folded plate.

6. Angle adjustment

Adjusting the bending angle is also the most important link. The angle selection must be related to the product requirements. Generally speaking, when folding 90 ° molds, the angle must be set, and the middle angle must be greater than the angle on both sides. Sometimes it may be tight, which can be handled by adjusting the screws on the machine. After adjustment, if the product does not change the demand, do not modify it. Then, when bending, calculate the accurate pressure figure through the pressure gauge and adjust the pressure. So as not to cause die edge collapse.